RODE Microphones M3 Manuel d'utilisateur télécharger pdf (Page 10)

- 10 -

L.E.D. SINGLE FLASH – When the L.E.D. ﬂ ashes

(illuminates for around one second), the battery power

is ‘good’. This indicates that the microphone has just

been powered.

L.E.D. STAYS ON – When the L.E.D. light illuminates

continuously the battery power is getting low. Please

replace the battery as soon as possible, as the

microphone’s sensitivity is greatly compromised when

operated with a low battery.

Note: When using M3 on battery power, it is a good

idea to keep the microphone in the off position when

not in use. This will save battery power and increase

the battery life. We recommend that during long

periods of non-use the battery should be removed, as

it may leak and potentially damage the microphone.

PAD switch

The PAD setting provides a -10 or -20 dB reduction in

sensitivity and is commonly referred to as attenuation.

To access the PAD switch unscrew the lower section of

the body to reveal the switch (ﬁ gure 6)

Figure 6 - PAD switch

A small screwdriver or pen can be used to alter the

switch positions as required.

A choice between 0dB, -10dB and -20dB settings can

be selected (ﬁ gure 7). We recommend you start with

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

RODE Microphones M3 Manuel d'utilisateur Page 10