Rode-microphones M3 Manuel d'utilisateur télécharger pdf (Page 9)

- 9 -

Operating the M3

The M3 may be connected to a mixer (recording or

live), and battery power will only be required if the

mixer does not have an in-built phantom P48 or P24

supply. Connection may also be made direct to a

portable DAT or other tape machine enabling ﬁ eld/

location operation using the 9V battery supply.

The M3 microphone has both a PAD switch and a

Filter switch.

On/Off Filter switch

The ﬁ lter switch is a multifunctional three position

switch. It will control main power (from battery),

microphone mute and ﬁ lter selection (ﬁ gure 5). Take

the time to learn what each position does so that you

can get the best performance from your M3.

The two-position variable

High-Pass Filter enables

you to step from a ﬂ at

response to 80Hz cut.

Use the high pass ﬁ lter

when you wish to remove

low frequency noise

that is not part of your

intended sound source. Remember however the

tonal characteristics will be affected by this, so it

is important that you listen to the sound both with

and without the HPF in circuit before deciding if it is

appropriate for the source.

L.E.D light indicator

The M3 has a handy power indicator light to help

notify you when the battery is running low.

L.E.D.

BATTERY POWER OFF

MIC MUTE

FLAT FILTER

HIGH PASS FILTER

Figure 5 - L.E.D. and Filter Switch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Rode-microphones M3 Manuel d'utilisateur Page 9